Aari embroidery sleeve design for baby shower function with tracing paper

on
Grand aari embroidery dad and baby sleeve design

Watch this video on YouTube


Materials Used:
  1. Aari embroidery iron needle for thread and beads
  2. Gold zari thread
  3. Sugar bead (2 mm to 2.5 mm size bead)
  4. Green sugar bead (2 mm to 2.5 mm size bead)
  5. Antic bead
  6. Oval shape clip stone
  7. Round shape stone
  8. Chakri
  9. Jarkan stone (Green colour)
  10. Fabric glue
Follow the steps:

Step 1- Trace the design, Use the tracing paper attached in below.

Step 2- Now start making the design of the sleeve bottom line. Start with a line of chain stitch using gold zari thread and complete with 4 lines.
 
Step 3- Mark the centre in sleeve to stick the clip stone.
Step 4- Apply fabric glue to stick round shape clip stone and stick 6 oval shape clip stone around the round shape clip stone for flower design.

Step 5- Now fill with sugar bead in middle of oval shape clip stone and end with antic bead.

Step 6- Draw the kodi design to connect one flower to another.

Step 7- Start to fill the kodi design using sugar bead.

Step 8- Now, fill the leafs with green sugar bead.

Step 9- To complete the design with a chain stitch around the kodi and leaf design.

Step 10- Place the chakri in the gaps and secure them with glue.

Step 11- Apply a thin layer of glue on chakri and place the jarkan stone.

Step 12- Now fill with sugar bead for mother and baby.

Step 13- Finally, complete with zari thread.

Step 14- Draw a straight lines and load with sugar beads and end with antic bead.

(Note: For face don't load with sugar bead, complete with zari thread for sharp finish)

Tracing paper:

Step 1- Trace the design, Use the tracing paper attached in below. Step 2- Cut out the design using a sharp pair of scissors. Step 3- Place the design on the fabric and pin it in place. Step 4- Sew the design/ make a holes on drawing onto the tracing paper using a sewing machine or by hand.

Step 5- Use tracing liquid to trace the design. Step 6- Remove the pins.

How to make tracing liquid using tracing powder: Step 1- Place the tracing powder in a bowl and add a few drops of kerosene. Step 2- Stir the mixture until it forms a thick paste. Step 3- Apply the paste on the designing paper and let it dry.


Thank you

Comments

Post a Comment